INSTALLATION AND OPERATING INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT ATTEMPT
TO INSTALL OR OPERATE
Model: 3301P
INTRODUCTION
This SKYTECH remote control system was developed to provide a safe, reliable, and user-friendly remote control system for gas heat-
ing appliance. The system can be operated thermostatically, manually or with the built-in factory program inside the transmitter. The
built-in program will control the appliance (7) days a week with (4) continuous time periods for each day. SEE PROGRAM SEQUENCE
BELOW. Custom programming may be achieved after the initial set has been performed.
This system operates on radio frequencies (RF) within a 20-foot range using non-directional signals. The system operates one of
1,048,576 security codes that are programmed into the transmitter at the factory; the remote receiver’s code must be matched to that of
the transmitter prior to initial use.
Review
COMMUNICATION SAFETY
under the
TRANSMITTER SECTION
and
THERMO SAFETY
under the
REMOTE RECEIVER
SECTION.
These signal/temperature safety features shut down the appliance when a potentially unsafe condition exists.
REV. 2-7-12 Page 1
Skytech: 3301P
INITIAL SET-UP OF TRANSMITTER
DOWN
UP
MODE
COVER
CLOSED
DOWN
UP
MODE
SET
PROG
AHEAD
BACK
TIME
TIMER
COVER OPEN
+
+
-
-
SMALL
BUTTON
BACK OF
TRANSMITTER
Fig. 1 Transmitter Front and Back Views
6:00AM
8:30AM
3:00PM
11:00PM
6:00AM
DAY
MORN
EVE
NIGHT
70°
60°
70°
63°
Built-in Factory Program
The transmitter operates on (2) AAA-size 1.5V batteries. It is recommended that
ALKALINE
batteries always be used for longer bat-
tery life and maximum operational performance.
IMPORTANT:
New batteries are essential for proper operation of the multi-function
transmitter.
The initial set-up of the transmitter is
IMPERATIVE
to ensure
the following:
Current Time - Hours and Minutes / AM/PM
•
Current Day of the Week - S, M, T, W, T, F, S
•
Proper Temperature Scale - F° (Fahrenheit) or °C (Cel-
•
sius)
To begin the initial set-up proceed with the follow-
ing steps:
1.
Remove the battery cover on the back of the transmitter.
Insert (2)
ALKALINE
AAA size 1.5 DCV batteries into the
battery compartment, positioning the (+) and (-) ends of the
batteries as indicated on the casing. When the batteries are
inserted properly, the LCD screen will display.
2
. Note the small button at the upper left side of the battery
compartment (Fig. 1). This button is used to perform the
initial transmitter set-up.
