e660
21 ·
e660
· 20
NiMH/NiCd Battery Program
NiMH/NiCd Battery Program
NiMH/NiCd Discharge Mode:
After selecting the correct battery type, use the
INC or DEC button to select the “DISCHARGE”
mode. Press the START button and the amp
rate value will begin flashing. Use the INC or
DEC buttons to adjust the value to the desired
discharge rate. Press the START button again
and the voltage cut-off will begin to flash. Use
the INC or DEC button to adjust the value to the
desired rate.
Follow the instructions provided on your battery
when setting the voltage cut-off. The e660 will
stop discharging when the battery has reached
the preset voltage cut-off.
NiMH DISCHARGE
1.3A CUT:9.6V
Press and hold the START button for 3 seconds
to start discharging. Once discharging has
commenced, the charger will display the
following real-time information: battery type,
discharging current, battery voltage, discharging
time and discharged capacity.
NiMH
1.3A
10.42V
AUT
002:22
00106
[ TIME: 00:04:04 ]
9.6V 00640mAh
When discharging is complete, the screen will
read “END: CUTOFF-VOL” and the charger will
emit a ringing sound.
The charger will display the elapsed time, end
voltage and the discharged capacity in mAh.
You can press the STOP button at any time
during the discharging process to stop the
discharge process.
NiMH/NiCd Re-Peak Mode:
Applicable to NiMH and NiCD batteries only, in re-peak mode the
charger can peak- charge the battery once, twice, or three times in a
row automatically. This process is good for confirming that the battery is
fully charged and for verifying how well the battery can accept a fast
charge. A five-minute cool-down delay occurs after each re-peak charge.
IN RE-PEAK MODE, THE e660 USES THE CHARGE AMPERAGE AND
VOLTAGE SETTINGS ENTERED IN CHARGE MODE.
NiMH RE-PEAK
2
NiMH 1.3A 10.42V
RPC 004:04 00686
After selecting the correct battery type, use the
INC or DEC button to select the “RE-PEAK”
mode. Press the START button and the Re-peak
cycle number 1 begins to flash on the screen.
Use the INC or DEC button to scroll through the
cycle count and set a number between 1 and 3.
Press and hold the START button for 3 seconds
to start the re-peak process.
Once the Re-Peak process has begun, the
charger will display the following real-time
information: battery type, charging current,
battery voltage, elapsed time and charged
capacity.
Once the Re-Peak process has completed, the
screen will read “END: RE-PEAK” and the
charger will emit a ringing sound. The e660 will
display the charge/discharge capacity for each
cycle. Using the + and - buttons, you can scroll
through the history data of each cycle.
Once the battery is fully charged, the screen will
read “END: FINISHED” and the charger will emit
a ringing sound. You can press the STOP button
at any time during the charging process to stop
charging.
