SkyPilot SkyExtender DualBand, Installation And Setup Manual

Page: 54 / 79

SkyPilot SkyExtender DualBand Installation and Setup Guide 54
TFTP Server Address.
Overrides Provisioning TFTP Server Address. (Leave blank for
now.)
Management HTTP Server Address.
Overrides Provisioning HTTP Server Address.
(Leave blank for now.)
VLAN ID.
A read-only field that automatically denotes the same VLAN as the
SkyExtender’s management VLAN. If there is no management VLAN, this field
shows 0.
NTP Server.
xxx.
Security Setting area
Use the Security Setting area of the Access Point Configuration page to enable
security services, provide passwords, and set up remote access of the access
point.
Figure 37. Security Setting area of Access Point Configuration page
SSH Server.
Check to enable the SSH server on the access point and permit
remote access to the device command line via SSH.
SSH Server Password. (Available only if SSH Server
is enabled) Use these fields to
set an SSH user name and password.
Telnet Server.
Check to enable the Telnet server for remote access of the access
point command line.
Telnet Server Password. (Available only if Telnet Server
is enabled) Use these fields
to set a Telnet user name and password.