User Guide to ST8050
ST8050UG001 – User Guide
14
Revision 2.0
Use AT&STREPORT command to setup those timers
AT&STREPORT=<mode>,<format>, <GPRS mask>, <Iridium mask>, <GPRS time On>, < GPRS time
Off>, <Iridium time ON>, <Iridium time Off>, <GPRS distance>, <Iridium distance>
<mode>
Report mode, indicates what condition must be used to
report:
0: Time condition
1: Distance condition
2: Time or distance condition
<format>
Indicates how the protocol must be formatted to be
transmitted.
0: Binary
1: ASCII
<GPRS mask>
Indicates which parameters will be embedded in the
report, this parameter is a numerical value in which each
bit represents a parameter as indicated by the following bit
mask:
Bit 0 – Location Data
Bit 1 – Digital Port Status
Bit 2 –Analog Ports Value
Bit 3 – GSM Strength
Bit 4 – Iridium Strength
Bit 5 – GSM Network Information
Bit 6 – GSM SIMCARD information
Bit 7 – Used by the ST8050 to indicate that an alarm was
triggered.
<Iridium mask>
Same as GPRS Mask
<GPRS time On> This parameter indicates the time interval in seconds that
the unit must report if the Digital port 1 level is high and
the GPRS modem has signal.
0 – Disable the report in this condition.
Range: 20 to 65535 seconds
<GPRS time
Off>
This parameter indicates the time interval in seconds that
the unit must report if the Digital port 1 level is low and the
GPRS modem has signal.
0 – Disable the report in this condition.
Range: 20 to 65535 seconds
