Assembly & Operation Manual
FUSELAGE CENTRE
Fit the ventral fin centre bottom of fuselage.
Some models have 2 ventral fins before LG.
Check operation of gear and doors. Fit loctite and
check all bolts and screws.
Run air lines and servo wires through fuselage.
Secure pipe in position and glue end of pipe with sili-
con glue to former.
Fit nose section to centre section with 4 bolts
Photo 39
Photo 40
FUEL CELLS
NOTE: Bad plumbing lead to flame outs. This will destroy
your model. Please take your time and do a good job.
Rinse fuel tank and check for leaks.
Make up fuel line fittings. Make sure clunk moves freely
and reaches all corners of inside of tank.
Fit to tank. Mark pipes for “inlet” and “outlet”.
Secure tank in position between inlet ducts.
Plumb tank using diagram
on next page.
Fill tank and check for leaks.
Drain tank with turbine fuel pump and check no air
Bubbles in system until last drop is drained. A good
plumbing will secure good turbine operation.
P-18
Photo 41
Photo 42
Photo 43
