Fit servo horn to 8911 flap servo. Centre servo and do setup for travel with TX.
Secure the servo to root flap rib. Use 4 screws. Mill slot in trailing edge of wing . This slot
for pushrod.
Mark location of flap horn on the LE of flap. Mill slot for flap horn. Using 30 minute ep-
oxy—glue horn to LE of flap.
Note : Make sure horn is supported by balsa block inside
the flap root. If no balsa, cut root of flap and insert balsa before you glue the horn to
flap. Always use ball links sandwidge by 2 horns.
Make up flap pushrod. Make up 2. Fit pushrod to servo horn and secure safety clip. Note:
See Pic 19.
Angle always 90 degree!
Slide pushrod through hole in trailing edge and insert safety clips.
Check that flap operate correctly and freely. Repeat for other wing.
Fit the servo horns to slat servos (8911) . Follow the same procedure as flaps.
Later models have new improved hinges and slat bulkhead link support. If your model
is not fitted, please contact factory.
Make sure slat travel do not open gap between wing and slat. Gap must always we close
.
Trial fit wings to fuselage and drill holes for servo wires.
Secure wing with 2 bolts on each side.
P-14
Assembly & Operation Manual
Photo 19
Photo 20
Photo 22
Photo 21
