Assembly & Operation Manual
STABILIZER (T-TAIL)
NOTE:
Make sure to have some sort of protective foam on the work bench. This will
protect the paint surface from unwanted dents. We suggest fit the stabilizer before join-
ing the fuselage. This will require less space. Mark √ each step.
Make up elevator pushrod.
Secure JR8911 servo to elevator mount with 4 screws.
Fit servo horn and centre servo using radio.
Fit the pushrod to horn. Secure with safety
clip. Impossible to adjust servo once tailpipe is fitted.
Remove the cover from the bottom of stab.
Locate the bolts to fit stab to belcrank.
Secure the stab to fin. Replace the covers.
Fit the top op elevator pushrod to elevator belcrank.
Secure safety clips.
Check operation of elevator servo and elevator.
If happy—fit the tip cover.
Run servo wires away from tailpipe.
P-15
Photo 23
Photo 25
Photo 26
Photo 27
Photo 28
Photo 24
