Page 56
December 2007
Rough Terrain Scissors
TM
Guardrail Folding Procedure
Section 3 - Operation
3.11 Guardrail Folding Procedure
When folded down, the folding guardrail system reduces
the height of the retracted MEWP for transporting only.
WARNING
Any lowered guardrail will create a fall
hazard. Remain away from the sides of
the platform while raising or lowering the
guardrails to avoid falling.
Left Side
Extension
Right Side
Extension
Front
Side
Right Side
Entrance
Side
Left Side
1
Figure 3-10a. Folding Guardrail System
1.
Guardrail Locking Pin with Lanyard
- This pin is
used to lock the guardrail in place.
WARNING
The scissor assembly must be fully
lowered before raising or lowering the
guardrails.
WARNING
Before operating this MEWP check the
guardrail system for loose or missing
locking pins. The guardrail system must
be upright and all pins must be locked in
place. Death or serious injury could result
if the guardrail system is not upright or
properly locked.
To fold the guardrail system down:
1.
Ensure MEWP is on level ground.
2.
Ensure extension platform is fully retracted.
3. Ensure “
” emergency stop button is
depressed.
4.
Turn main power disconnect switch to “ ” off
position.
WARNING
Ensure that you maintain three points of
contact when using the ladder to mount/
dismount platform.
5.
Use the ladder of MEWP to access platform.
6.
Close the gate.
7.
Remove the platform control console and
outrigger controls (if equipped) and lay it down
on the platform.
WARNING
Any lowered guardrail will create a fall
hazard. Use caution when exiting or
entering the platform when the guardrails
are lowered.
8.
Fold down guardrails in the following order: front,
right extension, left extension, right-side , left-side
and entrance (refer to
Figure 3-10a)
.
9.
Remove the locking pin that secured the
front
guardrail
to the left extension guardrail then swing
it towards the right extension and tie wrap front
gate to right side guardrail.
10. Remove the locking pin on the
right side
extension guardrail
and fold it down with the
front guardrail.
11. Remove the locking pin on the
left side extension
guardrail and fold it down.
12. Remove the locking pins on the
right side
guardrail and fold it down.
13. Remove all the locking pins on the
left side
guardrail and fold it down.
Summary of Contents for SJ6826 RT
