Skyjack SJ6826 RT, Operating Manual

Page: 45 / 92

Rough Terrain Scissors
December 2007 Page 45
Section 3 - Operation Start Operation
3.8-1 To Activate Base Control Console
1. Turn main power disconnect switch to “ ”on
position.
2. On base control console, pull out “ ” emergency
stop button.
3. For dual fuel engines, select fuel supply by moving
fuel switch to either “
” gasoline or “ ” liquid
propane gas position.
4. Insert key into platform/engine/base key switch
and select “
” base position.
5. For cold dual fuel engines, depress and hold
“
” choke pushbutton. For cold diesel engines,
depress and hold “ ” glow plug pushbutton
for 15 to 20 seconds.
6. Depress and hold “ ” engine start pushbutton
until engine starts, then release. Do not overcrank
starter. Release “
” choke pushbutton after
engine starts (dual fuel).
NOTE
Choke is only active while button is
depressed. Occasional use of choke
button may be necessary during the first
few seconds of engine operation.
3.8-2 To Raise or Lower Platform Using Base
Control Console
WARNING
Be aware of overhead obstructions or
other possible hazards around the MEWP
when lifting.
WARNING
Do not lower the platform unless the
area below is clear of personnel and
obstructions.
1. Activate base control console (refer to
Section 3.8-1 ).
2. On base control console, select and hold “ ”
base position on platform/engine/base key switch.
Select and hold platform raise/lower switch to
either “ ” raise or “
” lower position. Release
platform raise/lower switch to stop.