Telescopic Boom Series
Models SJ61T & SJ66T
194312
December 2007
Page 219
Section 5 - Procedures
Service and Maintenance
Axles
5.9-1 Change Oil in Axles
1. Ensure aerial platform is on a firm level
surface and is in stowed position.
2. Turn main power disconnect switch to off
position.
3. Place suitable container under the axle
4. Remove fill plug.
5. Remove all three drain plugs to allow oil to
drain into container.
Drain Ports
Check Port
FIll Port
Rear Axle (shown)
6. Reinstall all drain plugs.
7. Remove check plug.
NOTE
Axle is filled when oil is leaking from the
check port.
8. Refill axle with new oil as per specifications.
(Refer to
Section 2
of this manual)
9. Reinstall both fill and check plugs.
5.9-2 Check Oil Level in Torque Hub
1. Drive the aerial platform to rotate the hub
until the plug is located at 90 degrees.
2. Remove the plug and check the oil level.
The oil level should be even with the
bottom of the plug hole. Add oil if needed.
For oil specification, Refer to
Section 2
for
specifications.
Fill and Check
Drain
Drive Torque Hub
Summary of Contents for SJ61T
