Skyjack SJ46 AJ, Operation Manual

Page: 35 / 120

SJ46 AJ, SJ51 AJ, SJ63 AJ 213210AAAA
35
Optional equipment and attachments Section 3 – Familiarization
F
A
M
IL
IA
R
IZ
A
T
IO
N
3.5-5 Elevate™ telematics - access
control unit
Access control is an added function of the Elevate
™
Trackunit. The access control function does not
have an effect on: emergency-lowering, secondary
guarding electrical, load sensing, the horn, and when
you lower the platform. These functions are always
available. The access control unit does not allow the
engine to operate without an approved code or card.
IMPORTANT
The owner is responsible to supply PIN codes or
Smart ID cards for MEWPs that have the access
control function. Skyjack does not supply or reset
PIN codes or Smart ID cards. Speak to the MEWP
owner to help you with PIN codes or Smart ID
cards that do not function, or you cannot find.
With the access control function, the user can control
access to the MEWP operation. You can get unique
PIN codes or Smart ID cards to unlock and start
the MEWP. For this function, an Elevate™ telematics
device and an access control keypad are necessary.
With the Trackunit Manager, the MEWP owner can
customize the access control to the MEWP (https://
www.trackunit.com/services/manager/). Speak to the
MEWP owner to help you with PIN codes or Smart ID
cards that do not function, or you cannot find.
2
1
NOT USED
1
Orange indicator: This light shows that the
access control unit is ON. The keypad always
has power regardless of the emergency-stop,
base/off/platform key switch, or main power
disconnect position.
2
Green/red indicator: A green light shows that
the access control unit is in operation. A red light
that flashes shows that the keypad received a
cancel input.
Operation
To operate the MEWP, the light and all of these power
connections must be ON before the set time expires.
This set time is the time that the MEWP owner sets for
the access control operation.
▪
The green light on the keypad of the access
control unit.
▪
The main power disconnect switch.
▪
The emergency-stop button on the base control
console.
▪
The base/off/platform key switch.
You can also set these power connections to ON
before you start the access control unit.
To operate the access control unit, use the PIN code
or Smart ID card.
With the Keypad:
NOTE
This touch-sensitive keypad beeps to identify a
correct input.
1. Enter the PIN code.
2. Press the green checkmark to confirm.
▪
Result: The green light identifies an approved
ID. Start the operation.
NOTE
If you push an incorrect button when you enter
the PIN code, push the Cancel button to start
again.
With the Smart ID Card:
1. Put the card in front of the reader.
2. A beep identifies that the reader read the
card.
▪
Result: The green light identifies an
approved ID. Start the operation.