Skyjack SJ 68RT Series, Operating Manual

Page: 25 / 92

Rough Terrain Scissors
December 2007 Page 25
Section 2 - Familiarization Function Tests
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
contained in this operating manual and on the aerial platform.
F
AMILIARIZA
TION
2.4 Function Tests
Function tests are designed to discover any malfunctions
before aerial platform is put into service. The operator
must understand and follow step-by-step instructions
to test all aerial platform functions.
IMPORTANT
Never use a malfunctioning aerial
platform. If malfunctions are discovered,
aerial platform must be tagged and
placed out of service. Repairs to aerial
platform may only be made by a qualified
service technician.
After repairs are completed, operator must perform a
pre-operation inspection and a series of function tests
again before putting aerial platform into service.
Prior to performing function tests, be sure to read and
understand
Section 3.8 - Start Operation .
2.4-1 Test Main Power Disconnect Switch
1. In engine compartment, turn main power
disconnect switch to “ ” off position.
Result: Aerial platform functions should not
operate.
2.4-2 Base Control Console
WARNING
Ensure that you maintain three points of
contact when using the ladder to mount/
dismount platform.
1. Use the ladder of aerial platform to access
platform.
2. Close the gate.
3. On platform control console, pull out “ ”
emergency stop button.
4. Select low/high throttle switch to “ ” low
throttle position.
5. Use the ladder to dismount from platform.
6. Turn main power disconnect switch to “ ”on
position.
Platform/Engine/Base
Key Switch
Emergency Stop Button
Main Power Disconnect
Switch