139
SJ3220, SJ3226, SJ4720, SJ4726, SJ4732
223198ABA
Base
Section 5 – Procedures
E-0-0-8
Battery temperature out of range. Algorithm
dependent.
▪
Cool or warm batteries as needed.
▪
Check temperature sensor and connections.
▪
This error automatically clears once the condition has
been corrected.
E-0-1-1
Charge disabled by external command
▪
Charger has been disabled by an external controller
over the CANbus network.
▪
This error automatically clears once the command has
been removed.
E-0-1-2
Reverse polarity
▪
Battery is connected the wrong way around. Check the
battery connections.
▪
This error automatically clears once the condition has
been corrected.
E-0-1-3
Battery does not take current
▪
Check for an electrical component or loose connection
between the charger and the battery.
▪
When charging lithium batteries, make sure the charger
is properly connected to the battery and battery
management system.
▪
This error automatically clears once the charger is
disconnecting DC or AC.
E-0-1-9
Hardware build does not support software
version
▪
The charger hardware does not support the new
software version.
▪
Existing SW is left running. Contact Delta-Q
Technologies.
E-0-2-0
No active algorithm selected
▪
Reprogram the charger with its original software,
algorithms, and settings.
▪
Use the wrench button to select the correct algorithm if
still available on the charger.
▪
The problem clears automatically when an available
algorithm is set on the charger, as default.
E-0-2-1
High battery voltage while charging. Algorithm
dependent. Typically 2.8V/cell.
▪
When already charged, some new batteries may exhibit
this error.
▪
Disconnect the battery connection and wait for the
battery voltage to fall. Reconnect the batteries to see if
the condition reoccurs.
▪
Check battery size and condition. Batteries in poor
condition, with a high internal resistance, may cause
this error. New batteries, if charged when already full,
may also cause this error. Disconnect and reconnect the
batteries a few times.
▪
Check the battery voltage and cable connections.
▪
This error automatically clears once the condition has
been corrected.
Summary of Contents for SJ 3220
