SKS-Kinkel Elektronik GmbH
EN
il vetro Audio hands-free
Support-Hotline: +49 (0) 2661 98088 112
- 14 -
Version: 2.1
E-Mail: [email protected]
Document art. no. 97010301
3
Mounting instructions
3.1
Preparation
Use a screwdriver to release the il vetro Audio indoor station from its
supporting frame. This is done by inserting the screwdriver into the
release opening at the bottom of the il vetro Audio indoor station.
Carefully remove the il vetro Audio indoor station from the support
frame as shown in the drawing.
Pull the lower part of the il vetro Audio indoor station towards you and
carefully lift it upwards.
3.2
Mounting an flush mounted or cavity wall box
We recommend installing a flush-mounted or cavity wall box before
mounting the supporting frame so that it is possible to use the screws
to attach the supporting frame to the flush-mounted or cavity wall box.
Use the fastening holes in the center area of the supporting frame for
this installation.
We recommend additional fixation of the supporting frame with screws
in all four corners of the device.
Pay particular attention to the installation cable when mounting
the supporting frame!
Connect the terminals to the previously installed cable. The terminals
are located at the back of the il vetro Audio indoor station.
The pre-assembled cables are then connected to the il vetro Audio
indoor station.
To avoid errors when connecting cables please use the planning
guide or the wiring diagram.
