Skoda Superb 2006, Owner'S Manual

Page: 54 / 281

Unlocking and locking 53
Using the system Safety Driving Tips General Maintenance Breakdown assistance Technical Data
The sliding/tilting roof is operated by means of the control dial
⇒
fig. 32
and only functions when the ignition is switched on. The control dial has a
number of fixed positions.
After switching the ignition off, it is still possible to open or close the
sliding/tilting roof for a further 10 minutes. It is no longer possible to
operate the sliding/tilting roof after opening or closing one of the front
doors, however.
Note
•
If the battery has been disconnected and reconnected, it is possible
that the sliding/tilting roof does not close fully. Here you have to set the
control dial to the switch position
and press it forward for about 10
seconds.
•
It is necessary after each emergency operation (using crank handle)
to move the sliding/tilting roof into the basic position. Here you have to set
the control dial to the switch position
and press it forward for about 10
seconds.
Opening and tilting
Comfort position
– Turn the switch to position
⇒
page 52, fig. 32 .
Opening roof fully
– Turn the switch to position and hold it in this position
(spring-tensioned position).
Tilting roof
– Turn the switch to position .
The wind noise in the comfort position is less than when the roof is fully
opened.
The sun screen is also opened automatically when the roof slides open.
You can slide the sun screen into the opened or closed position by hand
when the sliding/tilting roof is closed. (This does not apply for models fitted
with sliding/tilting roof with solar cells, in which the sun screen is a fixed
element.)
Caution
It may be necessary during winter to remove any ice and snow in the area
of the sliding/tilting roof before opening it in order to prevent damaging the
opening mechanism.
Closing
Sliding closed/closing the sliding/tilting roof
– Turn the switch to position
⇒
page 52, fig. 32 .
Safety closing
The sliding/tilting roof is equipped with an overload protection system. The
sliding/tilting roof stops and moves back several centimetres when it
cannot be closed because there is something in the way (e.g. ice). You
can close the sliding/tilting roof completely without overload protection by
pressing the switch to the
position
⇒
page 52, fig. 32 at the front for as
long as it takes for the sliding/tilting roof to shut completely
⇒
.
WARNING
Close the sliding/tilting roof carefully - risk of injury!
A
A
A
A
A
C
A
B
A
D
A
A
A
A
NKO B5 20.book Page 53 Monday, July 3, 2006 2:09 PM