PRODUCT INFORMATION MANUAL
SECTION: 9G-B DUETTE
®
VERTIGLIDE
™
SIDE STACK DESIGN
POWERVIEW
®
MOTORISATION
ISSUE DATE: NOVEMBER 2017
ORIGINATOR: SKILTEC
REPLACES ISSUE DATE:
APPROVED BY: D.ALTIPARMAKOVA
PAGE 39
Removing the Shade (If Necessary)
You will need two people to remove the shade.
■
Detach the stationary rail bottom bracket from the wall or floor.
■
Remove the valance by reversing the installation procedures.
■
Hold the headrail assembly and, using a small
flat blade screwdriver, push back on the bottom
tab of the installation brackets to release the
headrail.
NOTE:
Because the bracket may be stiff, the
headrail may be difficult to remove. Twist the
screwdriver blade slightly as you push back the
bottom tab to help remove the headrail from
the bracket. Be careful not to scratch the finish
on the back of the headrail.
■
Place the entire Vertiglide
™
shade assembly
(headrail, vertical rails, and fabric panels)
on the floor.
■
To remove the fabric panels from the
headrail for cleaning, reverse the steps
stated in “Install the Fabric Stack” on page 11.
Cleaning Procedures
Luxaflex
®
Duette
®
honeycomb shades are made of anti-static, dust-resistant fabric which repels
dirt and dust. For most honeycomb fabrics, the following cleaning options are available.
Dusting
■
Regular light dusting with a feather duster is all the cleaning needed in most circumstances.
Vacuuming
CAUTION:
Do not vacuum Elan, Menage and Myst fabrics.
■
For deeper cleaning, vacuum gently with a brush attachment.
Compressed Air/Hair Dryer (Cool Setting)
■
Use compressed air or a hair-dryer on a cool setting to blow dust and dirt off shades.
Summary of Contents for DUETTE VERTIGLIDE SIDE STACK DESIGN POWERVIEW MOTORISATION 9G-B
Page 2: ......
