PRODUCT INFORMATION MANUAL
SECTION: 9G-B DUETTE
®
VERTIGLIDE
™
SIDE STACK DESIGN
POWERVIEW
®
MOTORISATION
ISSUE DATE: NOVEMBER 2017
ORIGINATOR: SKILTEC
REPLACES ISSUE DATE:
APPROVED BY: D.ALTIPARMAKOVA
PAGE 11
■
Attach the installation brackets using the screws provided.
IMPORTANT:
Be sure the front edges of the installation brackets are level and aligned to
each other. Use shims if necessary to level the brackets.
Mount the Headrail
■
Mount the headrail into the installation brackets. Do not remove any components from the
headrail. Both end plates should remain attached to the ends of the headrail.
➤
Place the front groove on the headrail onto the front lip of the installation bracket.
➤
Position the end of the headrail opposite the fabric stack flush against the jamb. This
leaves a gap on the stationary rail side. The stationary rail fills this gap when anchored.
➤
Rotate the rear of the headrail up and push back until the headrail snaps in place.
Gap
Left Stack Shown
Flush
Place Groove onto
Front of Bracket
Snap in
Place
Summary of Contents for DUETTE VERTIGLIDE SIDE STACK DESIGN POWERVIEW MOTORISATION 9G-B
Page 2: ......
