25
Assembly
Avoid unintentional starting of the machine.
X
During assembly and for all work on the
machine, the power plug must not be connected
to the mains supply.
Note:
To ensure safe handling, the rests of the base
plate
9
must be placed on a suitable supporting
surface (e.g., workbench, level floor, etc.).
Changing the Tool
(see figure A)
Before any work on the power tool itself, pull the
X
mains plug.
Use only cutting discs that have an equal or higher
maximal allowable speed than the noload speed of
your power tool.
Use only cutting discs that correspond to the characteristic
data given in these operating instructions and are checked
according to EN12413 and marked appropriately.
Removing the Cutting Disc
Place the machine in the working position. (see
–
“Releasing the Machine (Working Position)”,
page10)
For machines
–
with
retracting blade guard: Tilt
the retracting blade guard
10
upward to the stop.
For machines
without
retracting blade guard:
Unscrew the cover lid
23
.
Turn the hexagon socket screw
–
21
with the box-end
wrench
8
(size 15mm) provided and at the same
time press the spindle lock
11
until it engages.
Hold the spindle lock pressed and unscrew the
–
hexagon socket screw
21
.
Remove the washer
–
20
and the clamping
flange
19
.
Remove the cutting disc
–
12
.
Installing the Cutting Disc
If required, clean all parts to be mounted before installing.
Mount the new cutting disc onto the tool spindle
–
18
in such a manner that its lable faces away
from the tool arm.
Mount the clamping flange
–
19
, the washer
20
and
the hexagon socket screw
21
. Press the spindle
lock
11
until it engages and tighten the hexagon
socket screw. (Tightening torque approx.18–
20Nm)
For machines
–
with
retracting blade guard: Slowly
tilt the retracting blade guard
10
downward. For
machines without retracting blade guard: Screw
the cover lid
23
on again.
Operation
Transport Safety-lock
Before any work on the power tool itself, pull the
X
mains plug.
The transport safety-lock
6
enables easier handling of the
power tool when transporting to various working locations.
Releasing the Machine (Working Position)
Push the tool arm downward somewhat by the
–
handle
1
to releave the load on the transport
safety-lock
6
.
Pull the transport safety-lock
–
6
completely
outward and rotate 90 degree.
Guide the tool arm slowly upward.
–
Note:
When working, pay attention that the transport
safety-lock is not pushed inwards. Otherwise, the tool
arm cannot be lowered to the requested depth.
Securing the Machine (Transport Position)
Lower the tool arm until transport safety-lock
–
6
rotate 90 degree and can be pushed
completely inward.
