22
Power tool use and care
4.
Do not force the power tool. Use the correct
aa
power tool for your application.
The correct
power tool will do the job better and safer at the
rate for which it was designed.
Do not use the power tool if the switch
ba
does not turn it on and off.
Any power tool
that cannot be controlled with the switch is
dangerous and must be repaired.
Disconnect the plug from the power source
ca
and/or the battery pack from the power tool
before making any adjustments, changing
accessories, or storing power tools.
Such
preventive safety measures reduce the risk of
starting the power tool accidentally.
Store idle power tools out of the reach of
da
children and do not allow persons unfamiliar
with the power tool or these instructions
to operate the power tool.
Power tools are
dangerous in the hands of untrained users.
Maintain power tools. Check for
ea
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tool’s operation.
If damaged, have the power tool repaired
before use.
Many accidents are caused by
poorly maintained power tools.
Keep cutting tools sharp and clean.
fa
Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
Use the power tool, accessories, tool bits
ga
etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed.
Use of the
power tool for operations different from those
intended could result in a hazardous situation.
Service
5.
Have your power tool serviced by a
aa
qualified repair person using only identical
replacement parts.
This will ensure that the
safety of the power tool is maintained.
Safety Warnings for Cut Off Grinders with
Retracting Blade Guard
Secure the workpiece.
X
A workpiece clamped with
clamping devices or in a vice is held more secure
than by hand.
Do not work materials containing asbestos.
X
Asbestos is considered carcinogenic.
Take protective measures when dust can
X
develop during working that is harmful to one’s
health, combustible or explosive.
Example:
Some dusts are regarded as carcinogenic. Wear a
dust mask and work with dust/ chip extraction
when connectable.
Keep your workplace clean.
X
Blends of materials
are particularly dangerous. Dust from light alloys
can burn or explode.
Never leave the power tool before it has come
X
to a complete stop.
Cutting tools that are still
running can cause injuries.
Do not use the power tool with a damaged cord.
X
Do not touch the damaged cord and pull the
plug from the outlet when the cord is damaged
while working.
Damaged cords increase the risk of
an electric shock.
Connect power tools that are used in the open
X
via a ground fault circuit interrupter (GFCI).
Never stand on the power tool.
X
Serious injuries
could occur when the power tool tips over or when
accidentally coming into contact with the
cutting disc.
Make sure that the blade guard operates
X
properly and can move freely.
Never clamp the
blade guard in place while retracted.Ensure that
children do not play with the appliance
Use the power tool only for dry cutting.
X
Water
penetrating into a power tool increases the risk of
an electric shock
Keep hands away from the cutting area while
X
the machine is running.
Danger of injury when
coming into contact with the cutting disc
Never remove cutting remainders, metal chips,
X
etc. from the cutting area while the machine is
running.
Always guide the tool arm back to the
neutral position first and then switch the
machine off
Guide the cutting disc against the workpiece
X
only when the machine is switched on.
Otherwise, there is danger of kickback,\when the
cutting disc becomes wedged in the workpiece.
