0º
5º
10º
15º
20º
25
º
30
º
35
º
40
º
45
º
6
5
2
7
FIG. 22
FIG. 23
FIG. 24
9
34.
Miter Gauge Assembly
Locate the miter gauge lock handle
9
, washer
10
, miter gauge
11
,
and bar
12
from among the loose parts.
1. Place washer
10
onto end handle as shown (Fig. 22).
2. Insert handle
9
through slot in miter gauge
11
and thread into
bar
12
(Fig. 22).
Attaching Handle To Rip Fence
Locate the rip fence handle
17
from among the loose parts, and
thread handle into the rip fence
2
and tighten hex jam nut
3
to lock
handle against cam
4
(Fig. 23).
IMPORTANT:
Apply a coat of paste wax to the top surface and
front edge of the front guide rail
7
. This will allow the fence to slide
more easily.
Attaching Rip Fence
1. Raise rip fence handle
17
as shown (Fig. 24), so holding clamp
5
is out far enough to fit on the table
6
.
2. Position the rip fence
2
over table, holding up the front
end while engaging rear, then lowering front end onto rail
7
(Fig. 24).
Assembly
3
17
10
11
12
2
4
17