Skil 0320, Original Instructions Manual

Page: 4 / 44

4
LED Worklight 0320
INTRODUCTION
• The worklight is intended for
illumination in dry indoor areas
• This appliance is not intended for
professional use
• Check whether the packaging
contains all parts as illustrated in
drawing
6
• When parts are missing or damaged,
please contact your dealer
• Read this instruction manual carefully
before use and save it for future
reference
2
TECHNICAL DATA 1
Dimensions (width x depth x height) :
18,5 x 21,8 x 27,5 mm
Material shielding glass : tempered glass
APPLIANCE ELEMENTS 6
A Wing nut for assembly/fixation
B Lamp head
C Stand
D Wing nuts for adjusting lighting angle
E Shielding glass
SAFETY
• Handle the worklight with care
• Do not direct the light beam at
persons or animals and do not
stare into the light beam yourself
(not even from a distance)
• Do not cover off the lamp head
while operating the worklight (the
lamp head heats up during operation
and can cause burns when the heat
accumulates)
• Replace damaged shielding glasses
before using the worklight again
• If the power cord is damaged, send
the worklight to a SKIL service station
(addresses are listed on www.skil.
com)
EXPLANATION OF SYMBOLS
2
Read the instruction manual before
use
3
Do not stare into the light beam
4
Replace a cracked shielding glass
5
Do not dispose of the worklight
together with household waste
material
WHEN CONNECTING NEW 3-PIN PLUG
(U.K. ONLY):
• Do not connect the blue (= neutral) or
brown (= live) wire in the cord of this
appliance to the earth terminal of the
plug
• If for any reason the old plug is cut off
the cord of this appliance, it must be
disposed of safely and not left
unattended
USE
• Assembly
6
! ensure that the plug is
disconnected from the power
source before assembling the
appliance
- first unscrew wing nut A
- assemble lamp head B on stand C
with wing nut A as illustrated
- lock the worklight in place by
tightening wing nut A
• Operating the appliance
6
- connect plug to power source
! connect this earthed appliance
only to a properly earthed
power supply system; ensure
that socket and extension cable
have a functional protective
conductor
- the worklight is continuously
horizontally adjustable within its
pivoting range
- lock the worklight in place by
tightening wing nut A
- tilt the worklight into the desired
angle by loosening/tightening both
wing nuts D
MAINTENANCE / SERVICE
• This appliance is not intended for
professional use
• Clean the appliance with a dry or
slightly moist cloth (do not use any
abrasive or solvent-based cleaners)
! disconnect the plug before
cleaning
• The light source of this appliance
cannot be replaced (if the LED-light
reaches the end of its service life after