Skibo PEQUEA SF5, Operator'S Manual

Page: 13 / 18

11
OPTIONS AND ATTACHMENTS
Dual Conveyer Attachment
The side conveyer option is to be used as a double row fertilizer applicator. The speed of the
conveyer belts determines the distance the material is thrown out beyond the end of the convey-
ers.
Ensure the conveyors slide in and out freely as well as pivot about the center freely. If the con-
veyors do not slide in and out freely make sure there is no debris on sliding rails. If conveyors
do not pivot about center point freely ensure there is no debris between under side of conveyor
mounting plate and plastic slide pads. Also, check the tightening nut under the conveyor mount-
ing plate frame is not too tight preventing it from rotating.
Dual conveyer attachment
To change width of conveyors pull sping pin on each conveyor to detent position and move to
desired width. Each hole location is approximately 6” appart
*Do not adjust or preform maintenance on
conveyors while belt is in motion
Conveyor belts may need to be tightened periodically. If pulleys are slipping and belts are not
moving, tighten take-up bearings evenly until they begin to move
Grease fittings are located on the bearings at the idler pulley end of each converyor. Follow
proper grease techniques as described above
Apply proper chain lube to conveyor chain drive before every use, located under the cover at
the ends of each conveyor