AccuFlo
®
Zero
– Installation and Operating Instructions
4
Installation and operating instructions AccuFlo
®
Zero
1.4 Special warnings
Exceeding pressure:
Appropriate measures are to be taken to secure that the allowed operation pressure
according to the stamp on the type plate is not exceeded.
Normal usage:
On acceptance and within the required control intervals, a compression test under overpressure
and a leakage test have to be conducted for the whole system.
Exceeding or underrunning of the allowed operation temperature limits:
Appropriate measures are to be
taken to secure that the allowed operation temperature limits are not exceeded.
Damage:
Please observe that the product is not dropped and that it is not affected by excess forces.
Too many load cycles:
Appropriate measures are to be taken to secure that the allowed number of load cycles
is not exceeded. The maximum load cycles are defined in EN 13480-3; 10.2 c).
Opening under pressure:
Appropriate measures are to be taken to secure that the valves of the product are
not opened under pressure.
Fire near the product:
Appropriate measures are to be taken to secure that the product is taken out of
operation in case of damage.
Improper mounting of the flow computer:
Please observe that the several components of the product are
mounted properly.
Improper mounting of the device:
Please observe that the device is mounted properly.
Assembling of pieces of equipment, valves etc.:
In case of assembling of pieces of equipment and when
starting the working load, the pressure devices shall not be exposed to any loads which may endanger the
operating safety. Especially, additional static and dynamic loads are not allowed.
Welding of pieces of equipment:
Please observe that no welding, heat treatment or other interventions
concerning the safety are carried out. Necessary reparations have to be approved by the manufacturer.
Corrosion:
Please observe that the product is used and installed as intended.
Electricity:
Caution of voltage! Switch off the device before interfering in the wiring.
Other risks:
Please observe that the operation instructions of the manufacturer are respected at all times.
Especially, pressure devices have to be used for the specified media.
