Ski-Doo Skandic SWT 2013, Operator'S Manual

Page: 48 / 135

CONTROLS, INSTRUMENTS AND EQUIPMENT
mmo2011-007-004_a
1. Panel dowel
2. Tunnel hole
5. Lock the clip by turning it 1/4 turn
clockwise.
24) Drive Belt Guard
Drive Belt Guard Removal
WARNING
NEVER operate engine:
– Without shields and drive belt
guard securely installed.
– With hood and/or side panels
opened or removed.
NEVER attempt to make adjust-
ments to moving parts while en-
gine is running.
Remove the tether cord cap from en-
gine cut-off switch.
Remove LH side panels, see proce-
dure in this subsection.
Remove retaining pin.
mmo2008-003-063_a
TYPICAL
1. Retaining pin
Lift rear portion of drive belt guard,
then release from front tabs by pivot-
ing the guard outwards.
Drive Belt Guard Installation
When reinstalling drive belt guard,
position its cutaway toward front of
snowmobile.
Place the front LH slot of the drive belt
guard over the longest tab.
Pivot the guard inward to engage the
shortest tab in the RH slot.
mmo2009-003-010_a
1. Tabs
Position the grommet over the retain-
ing rod.
mmo2009-003-011_a
1. Retaining rod
Position rear portion of the drive belt
guard over the retainer and secure it
using the retaining pin.
46
______________