8
SKF TKSA 31 & TKSA 41
2. Getting started
2.1 Mounting the V-brackets
Use the V-brackets to attach the measuring units (MU) to the shafts.
Make sure the unit marked “
M
” is attached to the
Moveable machine
and the unit marked “
S
”
to the
Stationary machine
.
If it is not possible to attach the V-brackets directly to the shafts (e.g. in case of space problems) the fixtures can
be attached to the coupling.
For shafts with diameter < 40 mm (< 1.5”) hook the chain to the anchor
in the V-bracket from the inside.
The tightening knob should use the space closer to the rod.
For larger diameters hook the chain from the outside.
Remove the slack of the chain and tighten it firmly with the tensioning
knobs with the rod tensioning bar.
Make sure the rods are
firmly tightened
to the brackets before mounting the measuring units.
Make sure the measuring units are firmly tightened on the rods and DO NOT lie on bracket.
Brackets are symmetric, they can be mounted either way.
Summary of Contents for TKSA 31
