Operation
First use setup
!
Notice
The upper row of display (
17)
dis-
plays the current cycles/minute setting.
The lower row of display (
17)
displays
the new cycles/minute setting.
!
Notice
Pump activity can also be restart-
ed by first pressing
A (20)
to illuminate
display (
17
). Press
A (20)
again to re-
start pump (
† fig. 5
).
!
Notice
Follow the one time procedure
which is detailed below for first use set-
up only.
Do not use this procedure after first
use setup.
Fig. 5
Table 3
Run mode key options
Button
Action
Result
A
Press once
Upper row of display shows set cycles/minute
Lower row of display shows new/adjusted cycles/minute
Press twice
Turns display off; Restarts pump if pump not operating
B
Press once
Error display (00, no error)
Press twice
Upper row of display shows software version
Lower row of display shows battery percentage
TEST
Press once
Shut off the pump
Press twice
Restart the pump
14
15
8
17
18
19
20
21
22
• To manually stop pump activity and
overrun controller, press
TEST
(
22
).
• To restart pump activity, press
TEST
(
22
).
• If the battery life drops below 25%, red
LED light (
18
) will blink. To check this or
any error, press
B
(
21
).
Run mode
Refer to
table 3
for run mode options.
• Once overrun controller is properly
installed, press
A
(
20
) (
† fig. 5
)
to start
pump.
• When pump is running without any
errors, green LED light (
19
) blinks
continuously.
• If no key is pressed for more than
30 seconds after pump starts,
overrun controller goes into standby
mode and turns display (
17
) off to
conserve battery life. Pump and overrun
controller continue functioning while in
standby mode.
• To turn display (
17
) on while in standby
mode, press
A
(
20
).
1
Holding
TEST (22)
, press
B (21) + A (20)
+ B (21)
within 5 seconds (
† fig. 5
). Do
not release
TEST (22).
2
Continuing to hold
TEST (22),
adjust cy-
cles/minute value by pressing
A
(
20
). Each
key press will reduce the cycles/minute
value by 5 units.
3
Release
TEST (22)
and hold
B
(
21
) until
display (
17
) blinks. This indicates the cy-
cles/minute value has been stored. Unit
then automatically initiates run mode.
Setting cycles per minute
Do the following to modify the cycles/minute
setting:
4
Holding
TEST (22)
, press
B (21) + A (20)
+ B (21)
within 5 seconds (
† fig. 5
). Re-
lease
TEST (22).
5
Adjust cycles/minute value by pressing
A
(
20
). Each key press will reduce the cy-
cles/minute value by 5 units.
6
To store the cycles/minute setting, hold
B
(
21
) until display (
17
) blinks. Unit then
automatically returns to run mode.
6
