- 18 -
951-171-063
Version 01
EN
1. Safety instructions
1.21 Residual risks
Residual risk
Possible in life cycle
Prevention/ remedy
Personal injury/ material damage due to
falling of raised parts
A B C
G H K
Keep unauthorized persons away. No people may remain under suspended loads. Lift
parts with adequate lifting devices.
Personal injury/ material damage due to
tilting or falling of the product because of
non-observance of the stated tightening
torques
B C
G
Observe the specified tightening torques. Fix the product to components with ad-
equate load-bearing capacities only. If no tightening torques are stated, apply tighten-
ing torques according to the screw size characteristics for 8.8 screws.
Personal injury/ material damage due to
electric shock in case of damage to the
connection cable
B C D E F G H
Check the connection cable with regard to damages before the first usage and then at
regular intervals. Do not mount cable to moving parts or friction points. If this cannot
be avoided, use spring coils respectively protective conduits.
Personal injury/ damage to material due
to spilled or leaked lubricant
B C D
F G H K
Be careful when filling the reservoir and when connecting or disconnecting lubricant
feed lines. Always use suitable hydraulic screw connections and lubrication lines for
the stated pressures. Do not mount lubrication lines to moving parts or friction points.
If this cannot be avoided, use spring coils respectively protective conduits.
Loss of electrical protective function due
to faulty installation of electrical compo-
nents after repair
G
After replacement of electrical components carry out an electrical safety test accord-
ing to ISO 60204-1.
Reservoir with follower plate is subjected
to spring load
G
Remove reservoir with follower plate only when the spring is quite released (i.e. the
reservoir is empty). Provide adequate protective measure, e.g. fastening straps, when
loosening the reservoir. Do not work with your head directly above the reservoir.
Life phases:
A = transport, B = installation, C = initial start-up, D = operation, E = cleaning, F = maintenance, G = fault, repair, H = shutdown, K = disposal
