PRODUCT SPECIFICATIONS
Enclosure mechanical drawings
24 (29)
SKF Multilog On-line System IMx-Rail
User Manual Supplement
Revision B
3.5 Enclosure mechanical drawings
The SKF Multilog IMx-Rail is housed in a (black) powder coated, die cast aluminium
enclosure. It has overall dimensions of 260 mm long, 160 mm wide (excluding
glands, cabling and connector) and is 90 mm deep with fixing centres of 238 x 111
mm, refer
. The four mounting/fixing holes are 6.5 mm diameter (clearance
on M6).
Figure 5
IMx-Rail enclosure drawing
Important safety warning:
The low profile, circular antenna fitted to the enclosure lid, is 148 mm in diameter and
protrudes 32 mm above.
Three walls of the enclosure (two long and one short) are pre-fitted with blind plugs,
refer
for the drilling pattern/arrangement.
These (21) cable entries are supplied sealed, only remove the blind plug from entries
that will be actively used for cabling. Always then use an appropriate cable gland.
Depending on the actual gland used, an M20 gland will typically protrude no more
than 29 mm from the enclosure, but in all cases, a further allowance must be made
for the cabling used. In addition, note that on the back long wall, sufficient clearance
must be allowed for the power connector and mating cable, the connector location is
coloured red in
. The M12 plug (without mating connector) protrudes
approximately 15 mm from the enclosure.
Always utilise all provided fixing points to secure the enclosure to the
mounting surface.
