SKETCHNBUILD SNB-K96, Manual

Page: 21 / 25

22
Figure 15 Figure 16
8.8 Preheat
In the low temperature environment, influence of edge effect, the preheating switch
can be turned on the left side of the fuselage, for preheating plate. (Figure 16)
Chapter 9：
Abnormal phenomenon and its elimination
9.1 The common abnormal phenomenon and edge edgeing system：
phenomenon reason
solution
The glue doesn't reach the
working temperature.
Heating pipe burn Replace heating tube
Excessive amounts of glue on
wood
Too much glue Adjust the amount of glue
Edgeband with plate bond is
not strong
Too little glue Adjust the amount of glue
Lack of edge roller pressure
Increase the edge roller
pressure
Wood is too wet Replace wood
Easy to carbonization glue
Temperature control set too
high
Re adjust the temperature
Wood materials lack of tail
welt
Wood into the machine
position is not correct
When the wood is fed into the
machine, it is kept in
parallel with the feeding
guide rail
9.3 Fine trimming system common abnormal phenomenon and its elimination：
phenomenon reason
solution
The trim on the wood is not
sustainable.
The wood plane can not
accurately track profile
Increase the pressure profile
tracking
The wood is not perfect in Cam position changes Re adjust the cam position