SKETCHNBUILD SNB-K96, Manual

Page: 14 / 25

15
8.1 Plate thickness adjustment（Figure 3）
When the change of the thickness of the plate must be of material pressing height
corresponding adjustment: according to the thickness of the plate with special crank
rotation adjustment rod (1) to realize the numerical and the plate thickness is
consistent with that of the position of monitor. Clockwise rotation, the vertical plate
up, counter clockwise rotation, the vertical plate down.
8.2 After adjustment of supporting material device（Figure 4） ：
After the material holding device is mainly used for large workpiece edge support,
it can be adjusted according to the width of the workpiece. The adjustment method is
as follows: pull the handle on both ends of the support frame, and move it to the
appropriate position.
Figure 2 Figure 4
8.3 Control system（Figure 5） ：
Turn on the power control switch "A" start button, control power on.
Set the required temperature on the temperature control table B. When reaching the
set temperature, after ten minutes press the conveyor belt switch "E" start button,
conveyor belt running, press the corresponding switch motor operation.
In order to minimize the frequency converter, power outages, the system is not as
far as possible after the removal of artificial, to ensure the normal use of the
frequency converter.
When the wood into the machine touches the travel switch, push conveyor cylinder
edge forward. Board to enter the end of the trip to leave the trip, stop feeding.