Skanti TRP 9250 S, Technical Manual

Page: 206 / 227

DESCRIPTION
General
Correct installation of the DSC 9000 is important for maximum performance and reliability. This
chapter provides specific information about the installation of each unit, their interconnection and
connection to other equipment.
Mounting the Units
DCU 9000 Control Unit
The DCU 9000 control unit is adaptable to a variety of mounting methods and should be placed
with convenient operation in mind. It is installed separately with or without the mounting bracket.
DCU 9000 with Mounting Bracket
The mounting bracket (fig. 5 at page 7-4) is used for table mounting of the DCU 9000, and may
also be used for bulkhead and console mounting as shown in fig.6 at page 7-5 and fig.7 at page
7-6. Fig.7 shows how the mounting bracket may be installed behind a bulkhead or a console panel
for low profile mounting. Fig.8a and 8b at page 7-7 and fig.9a and 9b at page 7-8 shows how flush
mounting may be obtained and gives the dimensions for the necessary hardware.
External connections to the DCU 9000 are made to the terminal strips of the mounting bracket. For
top side cable entry the Terminal Board may be dismantled and turned 180 degrees as illustrated
in fig.10b at page 7-9.
DCU 9000 without Mounting Bracket
The DCU 9000 without mounting bracket may be bulkhead or console mounted as shown in fig.11
at page 7-10. Fig.12a and 12b at page 7-11 shows how flush mounting may be obtained and gives
the dimensions for the necessary hardware.
External connections to the DCU 9000 are made to the connectors at the back of the unit as
illustrated in fig.13 at page 7-12.
DESCRIPTION DSC INSTALLATION
TRP 9250 TECHNICAL MANUAL 5-3