sitrex SR 320/8 H, Use And Maintenance Spare Parts List

Page: 22 / 42

22
When the working height is being adjusted, set the screws (6) and relative nuts (8) so that
the machine as seen in picture is parallel to the ground.
After having adjusted the work height of the tine, use nuts (5) under support (10) to set the
distance of the plate from the ground.
The distance
between the swath-
shaper plate and
the rotor
determines the size
of the swath and on
this depends the
amount of forage.
Adjustment is
continuous and a
large amount of
forage means
making a larger
adjustment.
In order to carry out
adjustment, loosen
lock (21) and screw
(20) and then move
plate carrier (27) to
the required
position and tighten
first screw (20) and
then lock (21).
In the work position check that safety pin (13) fits into support (10) in order to fasten
the swath-shaper plate into position.
Adjustment of gear speed and revs to work the machine
The gear speed and machine revs depend on;
•
the amount of forage
•
the type of ground
•
the degree of dryness
The forage rake was designed for a maximum number of revs for the power take-off of
540 g/min. We advise working with a rev number of 350-450 g/min.Gear speed should be
limited so that the rake works cleanly and the swath is well formed.