sitrex SR 320/8 H, Use And Maintenance Spare Parts List

Page: 19 / 42

19
CHAPTER 5
ADJUSTMENT, PREPARATION AND USE
INTRODUCTION
Connection to the tractor is higly dangerous. Take great care and carry out the entire
operation in strict compliance with the following instruction.
Nobody should go near the area between the tractor and the machine.
Check that all warning and danger signs are in place and legible.
Check that the tractor is in good running order. Check the engine oil, gerbox oil, brake
fluid and cooling water levels as well as the tyre pressures.
Refer to the tractor operator’s manual.
CONNECTION TO THE TRACTOR
Connect the machine to the tractor, hitching it to the drawbar bar at point (1). If the
two-point crosspiece is used, lock the equalizers (10) using the optional screws (8)
and nuts (9).
Attention: do not use screws (8) if the machine is hitched to the
drawbar. After the machine is hitched, loosen the parking stand (2) and remove pin
(3), then rotate the stand upward towards the back of the machine and insert pin (3) to
hold it in the resting position.
Once this procedure is completed, insert the quick-release coupling (4) into the tractor
socket and open the tap (the lever must be parallel with the line, as shown in the
illustration). At this point, work carefully with the hydraulic distributor to make sure that
the frame is completely lowered, then adjust the height of the tines above the ground.
To change the distance between the tines and the ground, turn screws (6). By rotating
the crank (7), the tilt of the machine relative to the ground is adjusted.