Siruba ASP-EBJ100S, Instruction Book And Parts List

Page: 23 / 60

P14
Introduction
（４）鬆緊帶前端的設定
1.
打開電源開關
ON
時自動執行。
2.
從送料滾輪將新帶子送入的時候，為使第一
個帶圈的長度正確，請參照下列操作方法：
長按「復歸」開關③。（按
1
秒以上）可確
保鬆緊帶送入的前段位置是正確的。此時被
切斷的數公分鬆緊帶將被捨棄。
（５）啟動機器
1.
按「啟動」開關④。機器會拉出一段鬆緊帶
形成帶圈並準備送入縫製，此時機器會暫時
停止。
2.
請確認製品的接合或是重疊部分符合設定。
如果設定有問題請參照前述的處理方法。
3.
只有第一次需要將螺絲⑤鬆開後，將帶子前
端導引器⑥與帶邊貼平。
4.
之後選擇以下的操作。
a.
連續運轉。→
(6)
的操作
b.
只完成一個製品。→
(7)
的操作
c.
重新。→
(8)
的操作
（４）
Position forefront of elastic tape
1.Switch on the power and position
automatically.
2.In order to let the first elastic ring ’s length
correctly, after feeding roller send the
new elastic tape in, please follow the
operation below: Press the RESET switch
③
more than one seconds. It can insure the
forefront of elastic ring position correctly.
At the time, the centermiters of elastic tape
which been cut off would be abandoned.
（５）
Starting
1.Press START switch
④
, the machine will pull
a length of elastic tape which becomes
elastic ring, and start to send into sewing.
The machine would stop temporary at the
time.
2.Please make sure the seam or lap part of
the product fit the setting. If the setting has
any problems, please refer to the resolution
before.
3.Only the first time need to loosen screw
⑤
,
after, fit in tape edge front guide
⑥
to tape
width.
4.Then, follow the operation below:
a.Continuous operation.
→
operation (6)
b.Sewing one piece only.
→
operation (7)
c.Reposition elastic tape.
→
operation (8)
③
④
⑤
⑥