Siruba ASP-EBJ100S, Instruction Book And Parts List

Page: 15 / 60

P6
Introduction
1.
確認裝置高度
在尚未送電和送氣的狀態下，將夾住鬆緊帶
的夾具往下壓避免撞到其它部件①，再將送料
盤②往縫紉機位置推，盤上有紅線的面③和
縫紉機針板④為同一高度。當③比④低的時
候
(0.3
ｍｍ以內皆可），或③比④高
0.5
ｍｍ
以上的時候，將螺絲⑤鬆開（從圖片中的相反
側開始）
，旋轉高度調整螺絲⑥以微調整高度。
1.Check the height of the device.
Under the circumstance which do not turn
the power on and let the air in.Press the
clamp which clip the elastic tape down to
avoid bumping into other device
①
.Then
push the feeding plate
②
to the position of
sewing machine. The plate
③
surface which
has red line, and sewing machine needle
plate
④
are the same height. When
③
is
lower than
④
, (within0.3
ｍｍ）
or
③
is
higher than
④
(more than 0.5
ｍｍ
), loosen
screw
⑤（
start with the opposite side of
the picture
）
. Rotate the height, adjust
screw
⑥
to fine adjust the height.
3.
縫紉機操作面板
操作方法以及
LED
指示燈的說明請參照縫紉
機使用說明書。
3.Operation panel of sewing machine
Please refer to the instructions of operating
method and illustration of LED indictor
lamp.
機器啟動準備
PREPARATION OF OPERATING
MACHINE
②
⑥
⑤
④
③
①