6.3 Stand Alone Mode Installation (cont.)
6.3.2 Daisy Chain (Access Point)
Make sure the P
WiFi™ PCB and antenna are connected to a power source (5 Vdc).
ILOTINO
Connect the DMX IN/OUT wires to each of the MX Drivers in a sequence, similar to a daisy flower ring, to
D
each corresponding connector.
Power on the P
WiFi™ PCB once proper wiring connections are done to eliminate short circuiting the
ILOTINO
boards or controllers.
With the smartphone device, go to the “Settings -> WiFi/Network -> PilotWiFi_####, where #### is a
random sequence of four numbers.
When first prompted for a password, type PilotWiFi_0000.
Use any Art-Net iOS or Android App to drive the DMX devices.
13
3307 West Street Rosenberg, TX 77471 USA - (281) 324-0908
Copyright © 2006-2021 SIRS Electronics Inc. All Rights Reserved
P
WiFi™ PCB Instruction Manual
ILOTINO
Updated 12/2021. Rev 2.7
Summary of Contents for Pilotino WiFi PCB
Page 1: ...E518483 ...