PUTTING THE MEASUREMENT SYSTEM INTO OPERATION
Page 20 of 37
SICAT JMT
⁺
Jaw Motion Analysis System
PUTTING THE MEASUREMENT SYSTEM INTO
OPERATION
For the commissioning of the jaw motion analysis system, a USB cable of type A to Mini-B, as well as the
installation CD are required with the SICAT JMT
+
application software. All components are included in the
scope of delivery for the SICAT JMT
+
system.
POWER SUPPLY AND CHARGING THE BATTERY
For the rapid charging of the battery of the SICAT JMT
+
measurement system when it is in the deactivated
state, connect the charger with an AC outlet and a USB cable of type A to Mini-B with the Mini-USB socket
on the measurement system.
Alternatively, the measurement system can also be charged or operated directly on the USB socket of a
PC. To do this, connect the PC directly using a USB cable (type A to B or type A to Mini-B).
CAUTION
Only connect the USB charger that is approved and supplied by SICAT, and
arrange the measurement system such that the plug for the power socket is
easily accessible at all times and the device can be easily disconnected from the
mains.
NOTICE
Before connecting the charger to the mains, consult the name plate information
on the power supply unit, checking that the voltage and frequency is consistent
with the local data. Only connect if such consistency is given.
CAUTION
Carry out a full visual inspection to the power supply unit, power cable and plug,
as well as the protective contacts before the connection and/or operation of the
measurement system. Damaged power supply units, cables or plug connectors
must be replaced immediately by an authorized person.
COMPUTER REQUIREMENTS
For the requirements of the SICAT JMT
+
system with concern to a PC/laptop, please refer to the operating
instructions on SICAT JMT
+
software.
4
4.1
4.2
