35
Hold the handset in one hand so your fingers wrap around the back of the operating buttons area
of the handset. A green unlock light will illuminate when the handset has detected your hand. The
green light must be illuminated in this way for any of the command buttons to accept commands
to operate the fire control. Whilst the display is as shown, and holding the handset as described,
press the “SET” button with the other hand to finish off the pairing of the handset to the Fire
Control and to enter to setup the time of day on the handset. N.B. If the display returns to the
one shown above with the word “TESC” shown, then too much time has passed before pressing
“SET” and so the handset has not paired yet. Simply repeat pairing again.
Video available on
You Tube
Search for;
TESC Gas Control - Display handset pairing
Advanced settings Menu
In the event that you may want to change the other pre-set settings of the control features. Do
not do a long press and hold above but a normal short press and release will take you into the
advanced settings area.
Advanced settings options are:-
• Back light –
o A = Automatic (default setting). The back light comes on in the dark but not in the light.
o 0 = Light never comes on.
o 1 = Light comes on whenever handset is unlocked.
• Display contrast – 8 levels from 0 to 7 (default level 4).
• P = pairing with other devices other than the fire control.
The hand set can pair with other modules to:-
o L= Operate an electric light – which is the dimmable in 9 steps
o F= operate an electric fan –which can have 9 speed levels
o A= operate an auxiliary contact to operate another device.
CLEANING
Before carrying out any of the following operations, ensure that the fire is OFF and completely cold.
Debris that may form on the fire bed should be periodically removed by a competent person.
Large deposits could indicate deterioration of the flue. This should be repaired by a competent person, and
the fire serviced before further use.
FIRE FRONT/FRET - Any dust accumulating in the fire front may be removed using a vacuum cleaner or dry
cloth. Heavy stains may be removed by using a damp cloth and mild household detergent.
Brass parts of the fire front may be cleaned using a suitable brass cleaner.
Replace the front centrally against the fire after cleaning.
PAINTED AREAS - These can be cleaned using a dry cloth.
COALS AND CERAMICS
See the relevant section in the Installation Guide of these instructions.
Summary of Contents for Streamline 3
Page 17: ...17 Step 3 Step 4 ...