34
Operating instruction (Detailed)
1)
Upon successful insertion of the batteries in the Handset (if the handset has not previously
paired) the display will be as shown if it has been paired already then go to No 3.
1a)
If display is not as above the handset may well need to be reset before pairing.
Press and Hold “Set” Button, to enter Programing menu
When Set Up is flashing, press and release set to enter Setup Mode.
Press and Release the “Set” button several times until you see CAO displayed.
Then press and release “+” button once to change display to CA1
Press and Release the “Set” button once more to display TESC, handset is now ready to pair.
2) Pairing the Handset to the Fire Control
(paired at factory only do if re-pairing)
After fitting the batteries as above (and with the isolator slide switch on the TESC Fire
control in the ON position), simultaneously press and hold the – and + buttons on the fire
control (i.e. not the handset) 5- 10seconds – then LED on TESC lights – then within 2
seconds of LED light coming on, press the power (start stop ) button on TESC.
The handset will beep and green light flash
Summary of Contents for Streamline 3
Page 17: ...17 Step 3 Step 4 ...
