28
To achieve the HIGH setting, push the control knob in slightly and continue turning anti-clockwise to the
high position.
The main burner should light after a few seconds, to decrease the setting to LOW, turn the control knob
clockwise to the low setting.
To turn to the PILOT position from the HIGH or LOW positions, press the control knob in, and return to the
pilot position and release.
To turn the fire OFF, keep the control knob depressed, and return to the off position and release.
OPERATING THE APPLIANCE (Slide control)
For your safety, the fire is fitted with a Flame Supervision Device (FSD), which will shut off the Gas supply
if for any reason the pilot is extinguished.
Fit the 9V battery in to the battery lead at the left hand side of the fire.
This device incorporates a fixed probe, which senses heat from the pilot burner flame, if the probe is
cooled, the device will prevent any gas flow.
If for any reason the flames go out or if the fire has been turned off for any reason, always
WAIT FOR
3 MINUTES
before attempting to re-light.
The pilot is visible through the Fuel bed at the front of the fire; rotate the coals for good viewing
1.
From the standing position push the
thumb control all the way to the
bottom where a spark will be heard
and generated, hold down for
approximately 15 seconds.
2.
Release the pressure and the pilot
light should now be established (if this
fails repeat step 1 and hold down for
20 seconds).
3.
Slide the control upwards to increase
the flame size to the desired effect.
4.
To switch the fire off simple slide the
control upwards, passed the positive
stop and hold
fo
r 2 seconds.
