14
CHAP. 8 – USE OF THE MACHINE
8.1 – POSITIONING OF THE FILM (See Fig. n° 21)
ATTENTION! use only sealable film.
Before placing the film reel (
a
) on the machine, verify the sizes of the same
(see
Chart n.1).
Remove any protection material from the film reel and place it at the centre of the
suitable rollers
(b)
, carefully minding for the initial part of the film, which must be
unrolled.
Take the initial edge of the film, pass it over the first roller (
c
) and, then, slowly
pulling it downwards, passing it under the roller (
d
) and, then, under the film-
pressing sheet (
e
). Pull it in case of need until covering the entire tray to seal.
Fig. n°22
Fig. n°21
(d)
(b)
(a)
(e)
b
b
a
c
d
8.1.2 Positioning of the mould
(See Fig. n°22)
Before starting to seal, it is necessary
to verify whether the mould is placed in
the correct position.
Place the mould in the appropriate
space and match the holes of the same
with the two pegs present on the sealer.
7
which may ruin the surfaces, do not
dip it in water or in other liquids.
-
Do not leave the machine exposed to
harmful agents: sun, rain, sprays,
humidity, ice (
Fig. n°4
).
-
Do not pull the machine or the power
supply cable (
Fig.n°5
), to disconnect
the plug from the power source.
-
Regularly check the status of the
power supply cable; a used or, in any
case, a non-intact cable represents a
serious electrical danger.
-
Shall the machine remain unused for
long periods, before using it, an
“Assistance Centre” must check it.
-
Shall the machine give the impression
of or show a malfunction, it is
recommended to shut it off and to not
use, to not intervene directly for
repairs and to contact the “Assistance
Centre”, shown on the back of this
manual.
-
Do not keep the machine uselessly
on. Disconnect the plug from the power source when the machine is not being
used.
-
CAUTION! NEVER introduce your hands inside the hot machine, the
welding plate may cause serious burns.
Fig. n°4
Fig. n°5
CHAP. 3 – TECHNICAL SPECIFICATIONS
3.1 – SAFETY DEVICES INSTALLED ON THE MACHINE
3.1.1 – Electrical safety devices
As for the electrical safety devices, the machine described in this manual com-
plies with the:
-
low voltage directive
CEE 2006/95
;
-
electromagnetic compatibility directive
2004/108.
Despite the
CE
professional tray sealer is provided with the regulation measures
for electrical protections (both during the operation mode and during the cleaning
and maintenance stage), yet, there are some
RESIDUAL RISKS
which cannot
be completely removed, recalled in this manual under the entry
ATTENTION.
They relate to the danger of burns, deriving from the contact with hot parts of the
machine and cut danger deriving from the contact with the blade of the slitter.
