32
3.
Route the cable through the main cabin area under the interior trim,
towards the front of the vehicle . Use a blunt plastic putty knife or
similar blunt tool to lift the plastic trim just enough to tuck the cable
under underneath . Avoid side airbag locations on back pillars and
above the doors . Airbag locations are marked with “SRS” logos . Be
careful not to crimp or cut the cable .
4.
Bring the cable out from the trim near the front of the cabin and
route it under the carpet toward the dashboard or console . Coil any
excess cable in a hidden location, such as under the carpet, keeping
it away from any vehicle pedals or controls . Secure the excess cable
with wire ties (purchased separately) .
5.
Bring the end of the cable out at the
Power
Connect Vehicle Dock
location . Leave yourself enough cable so you can easily connect it to
the antenna connector of the dock .
6.
Continue with “Step 5: Connect the Magnetic Mount Antenna and
Power
Connect Power Adapter” on page 34 .
Pickup Truck:
1.
Use a blunt plastic putty knife or similar
blunt tool to lift the rubber molding
around the windshield and tuck the
antenna cable underneath it .
2.
Continue tucking the cable underneath
the windshield molding around the
windshield to the lowest corner .
3.
At the lowest corner of the windshield,
route the cable out of the windshield
Vehicle Installation
