Sirius Satellite Radio TTR1C, User Manual

Page: 71 / 88

71
Appendix: Manual Network Configuration
Connect to a Wired Network Using Manual Settings
In order to connect to a wired network, you will need to have the following
information to enter during the procedure:
Is DHCP enabled or disabled?
If disabled, the IP address to use for the radio?
If disabled, the Subnet Mask IP address?
If disabled, the Gateway IP address?
If disabled, the Primary DNS IP address?
If disabled, the Secondary DNS IP address?
a.
At the rear of the radio, remove the compartment cover and
connect an Ethernet cable to the Ethernet connector on the inside
left of the compartment . Refer to “Wired Ethernet Connector”
on page 11 for the location of the Ethernet connector . Replace the
compartment cover .
b.
Connect the other end of the Ethernet cable to your home’s wired
network .
c.
If you have just turned your SIRIUS TTR1C Internet Radio on for the
first time, the SSID screen will already be displayed . Skip ahead to
step f .
d.
Press MENU and turn the TUNE knob to highlight System Setup .
Press the TUNE Knob .
e.
Turn the TUNE knob to highlight Network . Press the TUNE Knob .
f.
Turn the TUNE Knob to highlight Manual Settings [Manual
config] . Press the TUNE Knob .