Sirius Satellite Radio SLT976, Installation, Use And Maintenance Instruction

Page: 33 / 52

33 34
SLT976 INSTALLATION
Remove the product from the package and place
it on a suitable surface: we suggest using a soft
material, such as a sponge or cloth.
Open the panel by turning it as shown in Fig.1
and remove it by releasing the 4 carabiners in
Fig. 2.
Remove the grease filters (Fig. 3).
Unscrew the 4 fixing screws (Fig. 4), separate
the hood frame from the upper part (Fig. 5) and
disconnect the electric cable (Fig. 5A).
Cut-out dimensions:
915 mm x 425 mm
The distance between the plasterboard and the
ceiling must be between 200 mm and 280 mm.
Make the four holes in the solid ceiling using an
8mm helical bit, following the dimensions in fig. 6
Insert the dowels supplied in the holes made.
Insert the threaded rods in the previously instal-
led dowels.
Screw the threaded rods using two nuts, as
shown in fig. 7, act in the low nut to screw the
threaded rod.
Insert an additional nut and the plastic locking
washer as shown in figure 8.
It is crucial, for a correct installation, to place the
metal washer 190mm high from the bottom surfa-
ce of the plasterboard, see fig. 9.
Install the upper part of the hood in the plasterbo-
ard niche already made, the 4 holes must coinci-
de with the threaded bars previously installed, as
shown in fig. 10.
Bring the product to the stop of the washers pre-
viously positioned.
Secure the product with the 4 washers and 4 nuts
supplied. (fig. 11)
Connect the air outlet ducting (fig. 12).
Take the frame of the dismantled hood and
position it under the opening made in the
plasterboard(fig.13).
Connect the previously disconnected motor cable
(fig.14A) and the power supply cable.
Fasten the frame to the upper part of the hood
using n. 4 screws (fig. 15).
Take the panel and hook it to the frame as shown
in figure 16.
Remove the two fixing angles of the lamps by un-
screwing the highlighted screws (fig. 17).
Take the ceramic lamps supplied (fig. 18) and
run their electrical cable first inside the panel (fig.
19A) and then inside the previously removed cor-
ner (fig. 19B).
Fasten the cable to the cable clamp using the
screws as shown in fig. 20
For a good installation, position the ceramic lamp
at an height of 1300mm from the top panel of the
hood and 700mm from the cook-top (see fig. 21),
to position it easily, take the cable out of the cable
clamp at a height of 150mm (fig. 21A).
Connect the electric cable of the lamp to the clip
in the hood canopy (fig. 22).
Restore the previously removed corner in the
special housing, making sure that the clamp is
positioned above the hood canopy (fig. 23).
To complete the installation, lock the panel to the
magnets (fig. 24).