Siqura XCU Series, User Manual, Page: 40 / 64

Device
Page 40
3
Drag the backup file ( with
.tar
extension) onto the dashed rectangle.
4
Click
Restore
.
The unit becomes unresponsive for some 30 seconds while the backup is restored.
9.2 Network
For correct functioning of the unit, its network settings must be compatible with the network to
which it is added. On the Network page, you can set a static IP address or enable DHCP to have
an IP address assigned dynamically.
After you make changes on this page, the unit must be restarted for the changes to take effect.
While restarting, the unit is unresponsive for 30 seconds.
Layout
The Network page has two tabs:

Network
Set a static IP address or enable DHCP
Configure HTTP, HTTPS and MTU settings

Services
Enable/Disable RTSP, ONVIF, MX and UPnP
9.2.1 Network
Host name
Identifies the unit on the network. You can set the host name on the Device Management page.
HTTP port
The port used for connections over HTTP. Default: port 80.
HTTPS port
The port used for secure communication over the network. Default: port 443.
Use DHCP
By default, DHCP is enabled. With DHCP enabled, the unit dynamically requests an IP address
and other networking parameters from a DHCP server on the network. There are two possible
outcomes.

A DHCP server is found and an IP address is assigned from its pool of addresses.
The unit can then be found with Device Manager - a software tool available for download at
http://siqura.com. You can use this tool to connect to the web interface of the unit.

No DHCP server is found.
The unit then reverts to its factory-set IP address. This is the same IP address as that found
on the sticker on the housing of the camera. To get access to the web interface, take the
following steps:
1. Set the network adapter of a browsing PC to the factory-default subnet of the unit.
2. Connect the unit to the PC.
3. From a browser on the PC, open the web interface of the unit and go to the Network
page.
4. Configure the network settings as needed.
It is also possible to request a time server address via DHCP. You can activate this function on
the Date & Time page.