Camera
Page 30
Word length
Determines the number of bits that is transferred in a single operation.
Stop bits
Indicates the end of a data character to enable the receiver to resynchronise with the stream.
Parity mode
Enables the sending of an extra bit with each data character for error detection purposes.
Wire mode
The RX-4xx interface type on the data connector is set in software. Select the required type in
the Wire mode list.
Biasing
If biasing is needed, it should be enabled on at least one module on the bus.
Termination
Normally, the devices at the two extremes of a bus are terminated, while intermediate devices
are not. Therefore: RS-422, always enable (being point-to-point); RS-485, enable only for the
first and last module connected to the bus configuration.
6.7
Privacy Mask
On the Privacy Mask page, you can mask one or more specific areas of the video streamed by the
unit.
Note:
Availability of this feature depends on the model at hand.
Add a privacy mask
1
Click
Add privacy mask
in the upper-right corner of the preview.
A dashed shape is added to the preview.
2
Move the shape to the desired location in the preview.
3
(Optional) Drag the resizing handles of the shape to adjust the scaling.
4
(Optional) Change the colour of the shape by selecting a colour from the colour list in the
lower-left corner of the preview.
Delete a privacy mask
1
Click the shape in the preview.
2
Click the recycle bin button in the upper-right corner.