Siqura HSD620PRH, Installation Manual, Page: 13 / 42

Page 9
C h a p t e r 4
4 Dome Setup and Cable Connection
Before installing or connecting the Siqura HSD620PRH and HSD621PRH, please refer to this
section and complete the preliminary preparations for setting up the dome camera and
establishing switch settings.
In This Chapter
Preparing the Siqura HSD620PRH and HSD621PRH for Installation 9
Switch Definition ................................................................ 10
Communication Switch Configuration .................................... 11
Establishing a Network Connection ....................................... 12
System Compatibility .......................................................... 13
Dome Cable Definition and Requirements .............................. 13
4.1 Preparing the Siqura HSD620PRH and HSD621PRH
for Installation
This preliminary installation procedure is for the Siqura HSD620PRH and HSD621PRH dome
cameras.
Perform the following steps to prepare the dome camera for installation
1. Unpack the dome package and take out the dome body.
2. Loosen the screws that secure the bracket to the camera as indicated in the figure below.
Camera unit before bracket attached
3. Temporarily remove the screw indicated below.
4. Assemble the bracket and rotate it into position.
5. Replace the removed screw and then tighten all four screws.