6
In the marked locations, drill each hole slightly smaller than the supplied screw anchors,
and insert the anchors into these holes.
7
Fasten the dome camera’s housing/plate with the four supplied self-tapping screws. Use
rubber grommets for outdoor installations.
8
Thread the cables (power/Ethernet/audio/alarm) through either the side conduit entry or
back conduit entry, as shown below. Use a coin to screw off the conduit entry block for
the FD820 camera.
The power cable is omitted if using PoE.
9
Connect the ports (on the camera module) with their cables/wires respectively, as
shown below.
Install the camera
19
