4
Detach the snap-on camera module from the FD820 camera’s housing/plate by
unscrewing the module-fastened Torx screw first.
Press the sides of camera module and pull it slightly out of the housing/plate.
5
Thread the power and/or Ethernet cables through either the side conduit entry or the
back conduit entry and fasten the camera’s housing/plate to the electrical box with the
two screws.
6
Connect the Ethernet cable to the camera’s network connector. Refer to Connectors for
details regarding the camera connector definition.
7
Connect the power and network outputs. Refer to Connectors for details regarding the
camera connector definition.
The power cable is omitted if using PoE.
8
Access the camera browser-viewer for viewing images. Please refer to the chapter
Accessing the Camera in the FD820 User Manual for further details. Users can also use
the camera’s BNC connector for video output.
9
Position the FD820's motorised lens and adjust the its zoom level and focal length via
the web page.
10
Adjust the camera’s pan/tilt holder to the desired angle.
Pan adjustment range is nearly 360°; rotation angle range approaches 270°.
Tilt is adjustable between -10° ~ 90°.
Install the camera
36
