6
GET TO KNOW YOUR HIGH PRESSURE CLEANER
FIG A
FIG A – 1
FIG B
Turning the detergent control
knob clockwise will increase
the detergent mix in the
water. Likewise turning this
knob counter-clockwise will
decrease the detergent mix.
The water inlet filter is located
inside the water inlet connection
(8) to access this unscrew the
connector and push out the
gauze filter for cleaning.
FIG C
7
VOLTAGE SETTINGS
PRELIMINARY PROCEDURES
Unroll the high-pressure pipe (16) completely.
Attach water supply pipe to the water inlet’s quick connection (8) using a normal garden
connector.
Open the tap to the water supply and make sure that there are no leaks.
Make sure that the main switch (3) is in the off position (the "0" position) and then plug into
the mains power supply.
Turn the main switch (3) to position "1".
Press the cleaner gun’s control lever (15) and wait for a continuous jet of water to be issued.
Turn the main switch (1) to position "0" and connect the lance pipe (10,11,12,13) to the cleaner
gun (14).
STANDARD OPERATION (HIGH PRESSURE)
Make sure that the Side handle (13) is twisted high pressure setting (also see the “Use with
detergents” section).
Restart the high pressure cleaner by turning the main switch (3) to position "1" and check that
the spray from the nozzle is uniform, without dripping.
Note: during this restart phase, the high pressure cleaner will immediately stop operating after
the initial peak, as the Total Stop device will take effect.
Use the cleaner gun’s lever (15) to start operation of the high pressure cleaner and thus start
cleaning.
The output pressure is shown on the pressure gauge (9).
USE WITH DETERGENTS
WARNING: The high pressure cleaner is designed to be used with recommended
detergents. Use of other detergents or chemicals can affect the safety of the high pressure
cleaner. Never suck up liquids which contain solvents, petrol, diluents, acetone and fuel oil, as
these products are highly inflammable, explosive and toxic when nebulized.
Read the instructions and warnings on the label of the detergent to be used.
Store detergents in a safe place out of children’s reach.
Should detergent come into contact with your eyes, wash immediately with water. Contact a
doctor without delay and remember to take the container of detergent with you.
If detergent is swallowed, do not provoke vomiting. Contact a doctor without delay and
remember to take the container of detergent with you.
When filling the tank with detergent, take care not to spill any detergent on the high pressure
cleaner. If this should happen, wait at least 24 hours before using the high pressure cleaner so
that any liquid, which may have entered the appliance, can evaporate.
Pour the detergent into the detergent tank (20) by removing the tank cap (19) replace cap as
soon as the detergent tank is full.
- unscrew the cap (19) and fill the tank taking care not to spill the liquid (maximum capacity 4lt /
1.06 US gal); follow the recommendations regarding the doses indicated on the label on the
container of detergent;
-twist the side handle (13) as illustrated in Fig. A and then operate the trigger (15) on the
cleaner gun and start releasing the detergent;
- twist the side handle (13) as illustrated in Fig. A-1 to restore high-pressure operation.
(suction and mixing occurs automatically as the water flows).
The detergent mix can be adjusted by turning the detergent flow control knob as indicated in fig
B
